Velocity Performance Products, Throttle Sensitivity Controller Review!



W3Schools

Website : https://www.v-p-p.ca
NEW! Make sure ignition is turned off for at least 10 minutes before installing.
Locate accelerator pedal electrical connector and disconnect.
Plug corresponding connectors into respective plugs.
Tie wrap the cables out of the way.
Determine a good location for TSC Controller placement where it will be easily accessible.
Mount using the supplied 3M Velcro 2 sided tape
Turn on ignition the Power Level LEDs will be in pre calibration mode (chasing)
VERY IMPORTANT PART READ CAREFULLY AND UNDERSTAND BEFORE PROCEEDING
PUSH AND HOLD BOTH THE UP AND DOWN BUTTONS BEFORE PRESSING ON THE ACCELERATOR PEDAL THEN WHILE BUTTONS ARE PRESSED PUSH THE ACCELERATOR TO THE FLOOR
RELEASE THE 2 BUTTONS WHILE THE ACCELERATOR IS STILL TO THE FLOOR
AFTER YOU RELEASE THE BUTTONS YOU CAN REMOVE YOUR FOOT FROM THE PEDAL
Only the first LED should be illuminated at this time.
Start vehicle, and you are done

Tech Reviews and Gadgets: https://www.youtube.com/playlist?list=PL4hlirXfjCJPUNgeF0UWXys4epktngAfh

Teeth Whitening: https://www.youtube.com/watch?v=HoNz4dB2K2cI

Instagram: http://www.instagram.com/911reviews

http://youtube.com/c/911Reviews?sub_confirmation=1

Sponsor a video for as little as $200. Contact: AllStarBoxOffice@gmail.com

This page is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for website owners to earn advertising fees by advertising and linking to amazon.com, audible.com, and any other website that may be affiliated with Amazon Service LLC Associates Program.

source

W3Schools

0 replies

Leave a Reply

Want to join the discussion?
Feel free to contribute!

Leave a Reply

Your email address will not be published. Required fields are marked *